Victory 9/10 Technical Troubleshooting Guide www.pridemobility.com 7
5. Unplug connector 1c from connector 3a and connector 2c
from connector 3b.
See diagram 3
.
6. Measure voltage across pin 1 and pin 2 on connector 1c and
connector 2c.
See figures 6 and 7
.
— If your multimeter indicates greater than 9VDC for both tests,
then plug connectors 1c and 2c back into connectors 3a and 3b
and go to the next step.
— If your multimeter indicates 0VDC on either test,
then replace
either the left or right battery harness (1 or 2) and retest the
system.
7. Measure voltage across connector 1a (-) and connector 2b (+).
See figure 8
. {
If your multimeter indicates 0VDC,
then
measure voltage across connector 1b (+) and connector 2a (-).}
— If your multimeter indicates 0VDC for both measurements,
then go to the next step.
— If your multimeter indicates greater than 18VDC on either
measurement,
then go to
step 10
.
8. Remove the battery connector module.
See figure 9
.
9. Measure resistance across the circuit breaker (4) terminals (4a
and 4b).
See figure 10
.
— If your multimeter indicates less than 1 ohm,
then replace the
controller power harness (3) and retest the system.
— If your multimeter indicates greater than 1 ohm,
then replace
the circuit breaker (4) and retest the system.
Figure 7. Connector 2c
Figure 6. Connector 1c
Figure 9. Battery Connector Module Removal
Figure 10. Circuit Breaker (4)
Figure 8. Connectors 1a and 2b
1
a
-
1
b
+
2
a
-
2
b
+
4
a
4
b
MANDATORY! Battery posts, terminals,
and related accessories contain lead
and lead compounds. Wear goggles and
gloves when handling batteries and
wash hands after handling.
WARNING! Always protect the batteries
from freezing and never charge a frozen
battery. Charging a frozen battery may
result in damage to the battery.
WARNING! Connect your battery har-
nesses in the proper manner. RED (+)
cables must be connected to positive (+)
battery terminals/posts. BLACK (-)
cables must be connected to negative (-)
battery terminals/posts. Protective caps
should be installed over all battery ter-
minals. REPLACE cables immediately if
damaged.
