4
www.pridemobility.com Victory 9/10 Technical Troubleshooting Guide
INTRODUCTION
VICTORY 9/10 TECHNICAL TROUBLESHOOTING GUIDE
This Victory 9/10 Technical Troubleshooting Guide covers diagnostic and repair scenarios for Victory 9 and 10 scooters.
This guide is divided into three sections to address three troubleshooting scenarios:
Section 1 — Key Inserted Into Key Switch And Turned On - No Signs of Power
Section 2 — Key Inserted Into Key Switch And Turned On - Powers On But the Scooter Will Not Drive
Section 3 — Beep Code Diagnosis
How to use this Pride Model Specific Technical Troubleshooting Guide
All Pride Model Specific Technical Troubleshooting Guides follow the same format. They are divided into sections
addressing symptoms such as Key Inserted Into Key Switch And Turned On - No Signs of Power and Key Inserted Into
Key Switch And Turned On - Powers On But the Scooter Will Not Drive. If the mobility product is capable of giving
beep codes, one section will deal with each code for that model.
The troubleshooting guide utilizes diagrams that are located on the insert sheet(s).
See figure 1
. These diagrams identify
main components by number (1, 2, 3, etc.) and all connectors by number with a lower case extension (1a, 2a, 3a, etc.).
The diagrams also show how all of the components are connected.
Using the Table of Contents, locate the section that best describes your troubleshooting issue. Each section will include
a list of symptoms, followed by a diagnosis of the problem, and finally a solution or procedure to solve the problem. The
procedure is set up as a numbered list of instructions, which may include one or more tests. Results of these tests will:
Direct you to change a component and retest the system.
Go to the next numbered step.
Advance to a numbered step farther along in the section.
Figure 1. Diagram Insert Sheet(s) (Located Within the
Manual)
System Retest
When a procedure specifies to replace a component,
you must retest the system after replacing the component.
To retest the system:
1. Remove the key.
2. Replace the component.
3. Reconnect any harnesses that were disconnected.
4. Insert the key and turn on the power.
— If the scooter operates normally,
then reassemble
the scooter.
— If another problem has surfaced,
then go to that
procedure in this guide.
Use Diagram Insert for Reference
