Victory 9/10 Technical Troubleshooting Guide www.pridemobility.com 13
Figure 26. Connector 15a
Figure 29. Connector 7a
Figure 27. Connector 7a
3. Unplug connector 15a from connector 10h.
See diagram 2
.
4. Measure resistance across pin 1 and pin 2 on connector 15a.
See figure 26
.
— If your multimeter indicates about 2.5k ohms,
then replace the
controller (8) and retest the system.
— If your multimeter does not indicate about 2.5k ohms (and is
off by at least 0.5k ohms),
then replace the throttle pot (15) and
retest the system.
Beep Code #7 - Throttle Trip
Symptoms:
The controller (8) beeps seven times.
Diagnosis:
The controller (8) may be faulty.
The throttle pot (15) may be faulty.
The speed pot (17) may be faulty.
The tiller harness (10) may be faulty.
The controller interface harness (7) may be faulty.
Solution:
Use the following procedure to clear the beep code:
1. Remove the seat.
See figure 4
.
2. Remove the main shroud.
See figure 11
.
3. Remove the cover from the controller (8).
See figure 12
.
4. Unplug connector 7a from connector 8a.
See diagram 3
.
5. Measure resistance across pin 2 and pin 8 on connector 7a.
See
figure 27
.
— If your multimeter indicates about 4.7k ohms,
then go to the
next step.
— If your multimeter does not indicate about 4.7k ohms,
then go
to
step 9
.
6. Measure resistance across pin 1 and pin 8 on connector 7a.
See
figure 28
.
— If your multimeter indicates about 2.5k ohms,
then go to the
next step.
— If your multimeter does not indicate about 2.5k ohms,
then go
to
step 9
.
7. Turn the speed pot (17) to the full rabbit position.
8. Measure resistance across pin 8 and pin 9 on connector 7a.
See
figure 29
.
— If your multimeter does not indicate about 4.7k ohms,
then go
to the next step.
— If your multimeter indicates about 4.7k ohms,
then replace the
controller (8) and retest the system.
Figure 28. Connector 7a
