Jazzy EVO 614 Series
www.pridemobility.com
13
V. C O M F O R T A D J U S T M E N T S
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to
increase your comfort, such as seat height, armrest angle, foot platform height and angle, and controller position.
Refer to the following information before making comfort adjustments.
NOTE: If your power chair is equipped with an optional seating system, please refer to the information provided
in separate manuals.
WARNING! The center of gravity of your power chair was factory set to a position that meets
the needs of the demographic majority of users. Your authorized Pride Provider has evaluated
your power chair and made any necessary adjustments to suit your specific requirements. Do
not change your seating configuration without first contacting Pride Mobility Products or your
authorized Pride Provider.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
Seat Height Adjustment
You can change the seat height to one of three
positions in 1-in. (2.5-cm) increments.
To change the seat height:
1.
Turn off the power to the controller.
2. Ensure the power chair is in drive mode.
See
figure 4.
3. Disconnect the controller connector from the
power base.
See figure 8.
4. Disengage the seat release lever.
See figure 8.
5. While holding the lever, swivel the seat left or
right and then pull it up and off of the power
base.
6. Remove the screws to remove the top shroud.
7. Loosen the hardware at the rear of the seat post.
See figure 8.
8. Remove the seat height adjustment bolt, washers,
and nut from the seat post.
See figure 8.
9. Raise or lower the seat post to the desired
position.
10. Reinstall the seat height adjustment hardware to
the seat post and tighten hardware at the rear of
the seat post.
11. Reinstall the top shroud and tighten the screws.
12. Tighten the hardware at the rear of the seat post.
13. Reinstall the seat.
14. Reconnect the controller to the power base.
NOTE: To rotate the seat, use the seat release lever
located under the seat.
Figure 8. Seat Height Adjustment
1. Seat
2. Seat Post
3. Seat Height
Adjustment Bolt
4. Controller Connector
5. Seat Release Lever
6. Top Shroud
Identification Key
2
3
1
5
4
6
