Pretorian Simplyworks ENERGISE, Instructions Manual

Page: 8 / 8

www.pretorianuk.com
Unit 37 Corringham Road Industrial Estate
Gainsborough Lincolnshire DN21 1QB UK
Tel +44 (0) 1427 678990 Fax +44 (0) 1427 678992
SimplyWorks® is a registered
trademark of Pretorian Technologies Ltd
S040007:2
Refers to firmware version 44.3 and later
Troubleshooting
Symptom Possible Cause
No power to ENERGISE
• Not plugged into wall
socket
• Wall socket not
functioning
• Fuses in ENERGISE blown
Remedy
Wired switch does not operate
appliance
• Switch lead broken
• Switch not plugged into
correct socket
• Unit is set to
Co-operative mode
• Appliance not functioning
• Appliance has its own
power switch
• Another switch on the
same channel is already
pressed
• Test with Pretorian Test-IT
and replace if necessary
• Change to correct socket
• Change to another mode
• Plug into a separate wall socket to test.
Replace if necessary.
• Ensure that switch is set to on.
• Release the switch
Wireless switch does not
operate appliance
• Switch not paired (watch
for Pair LED blinking).
• Unit is set to
Co-operative mode
• Appliance not functioning
• Appliance has its own
power switch
• Another switch on the
same channel is already
pressed
• Follow pairing sequence for required
channel.
• Change to another mode
• Plug into a separate wall socket to test.
Replace if necessary.
• Ensure that switch is set to on
• Release the switch
Appliance does not turn off
using switch
• Unit may be set to a timed
mode.
• Unit may be set to On/Off
mode.
• Another switch on the
same channel is already
pressed
• Check mode setting and change if
necessary.
• Check mode setting and change if
necessary.
• Release the switch
• Plug unit in!
• Check household fuses/ circuit
breakers. Replace or reset if necessary.
• Check 8A fuse at rear of unit. In UK
units check 10A fuse in plug. Replace if
necessary.
Check 0.2A circuit board protection
fuse. This should be carried out by
qualified service personnel .