Charging your J-Pad
Before using your
J-Pad
ensure the battery is fully charged by plugging the charging cable into
the charging socket [F] and the USB connector into a computer USB port. The charging LED [E] will
illuminate (green) to show charging is taking place. Once charged the LED is extinguished.
Bluetooth Connections
Once connected with a specific iPad your
J-Pad
will no longer be visible (‘discoverable’) to other iPads.
If you turn off your iPad, disable Bluetooth, or go out of range of the
J-Pad
the connection between
the two devices is automatically re-established when you next power-on, turn on Bluetooth or go back
into range.
To connect to a different iPad please refer to the ‘Connecting your
J-Pad
to a different iPad’ section
in the manual.
Connecting to your iPad
Wake up
J-Pad
by moving the joystick in any direction. The status LED [D] will flash rapidly to indicate
that it is not yet paired with an iPad. If the LED does not flash rapidly, please refer to the ‘Connecting
your
J-Pad
to a different iPad’ section of these instructions.
Go to the Bluetooth menu on your iPad (Settings Bluetooth). Ensure Bluetooth is turned on using
the slider at the top of the screen.
After a few seconds
J-Pad
should appear as a ‘discoverable’ device which will appear as something
similar to:
Pretorian-V56.1-ABC1
Tap on the name and the pairing process will begin. Typically it takes around 20 seconds to connect,
after which the iPad will state the device is ‘connected’.
Changing Mode Settings
To establish the current Mode setting, or to change it, first put the unit into Programming Mode by
pressing the Feature Button [G] for approximately 2 seconds. The unit emits a warbling beep as it
enters Programming Mode and the status LED [D] lights.
While in Programming Mode, move the joystick [A]
downwards
and listen to the number of beeps that
are emitted from the unit. This tells you the current setting without making any changes, according
to the following table:
Once the current Mode setting has been established, should you wish to make a change, simply move
the stick
downwards
a number of times until the correct number of beeps are emitted. Once you are
happy with the setting, press the Feature button [G] briefly and the unit emits a warbling beep once
again to indicate it is leaving Programming Mode and storing the new settings.
Note that this table is also shown on
the rear of
J-Pad
for easy reference.
1 Beep
Mode 1
2 Beeps
Mode 2
3 beeps
Mode 3
4 Beeps
Mode 4
5 Beeps
Mode 5
Summary of Contents for J-Pad
Page 7: ......
