11
Device Setup
Getting started with Micro Current Device is easy.
To Install or Replace Batteries
1. Make sure power is in the Off position.
2. Remove Outer battery-compartment cover by holding the device and pulling
outward the lift tab.
3. Lift and pull open Inner battery-compartment cover.
4. Carefully pull out batteries (if replacing) and insert 3 new “AA” batteries.
Use the markings in the battery compartment as a guide to position
the (+) positive or (-) negative end of each battery.
5. Replace back batter compartment cover by firmly pressing into place -
keeping silicone seal in place, and then replace the outer battery cover
by aligning the lower tab into slot and pressing firmly to close.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon zinc)
or rechargeable (nickel-cadmium) batteries. To dispose of alkaline batteries,
place in the trash (normal municipal waste). Recycling of batteries at your
local recycling center is good for the environment.
Important Information
It is our experience that if a product uses batteries, many of the problems thought
to be product defects are simply caused by weak batteries. To save any unnecessary
inconvenience and expense, we encourage you to always replace with new batteries.
Getting Started
