APS57TM_RevA_07/20
2
Detailed Descriptions:
Wire Harness Colors and Func�ons
Power Connector (6-pin High-Current Connector)
See page 22 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
1. YELLOW – Starter Output for Remote Start (+)
The YELLOW wire supplies 12-Volt (+) to the vehicle’s starter wire when remote start is enabled, and turns off once the
vehicle is started.
Verification:
This starter wire registers 12-Volt (+) during engine crank.
3. RED – 12-Volt Input (+)
The RED wire connects to the vehicle’s primary 12-Volt (+) wire to power the system.
Verification:
The power wire registers 12-Volt (+) at all �mes.
Note:
Before making this connec�on, remove all module fuses un�l the system is completely connected.
2. GREEN – Ignition 2 Output (+)
At its default setting, the GREEN wire supplies 12-Volt (+) to the vehicle’s secondary igni�on wire during remote start.
Verification:
If present, the secondary igni�on wire registers 12-Volt (+) when the vehicle is in igni�on mode AND during
engine crank.
Note:
This wire can be programmed to perform a different func�on by changing its op�ons.
Refer to Bank 3, Feature 7
on page 10.
4. RED/WHITE – 12-Volt Input (+)
The RED/WHITE wire connects to the vehicle’s secondary 12-Volt (+) wire to power the remote start func�on.
Verification:
The power wire registers 12-Volt (+) at all �mes.
Note: Before making this connec�on, remove all module fuses un�l the system is completely connected.
1
3
5
2
4
6
6. BLUE – Ignition 1 Input / Output (+)
The BLUE wire supplies 12-Volt (+) to the vehicle’s primary igni�on wire during remote start. This wire is also used to
sense vehicle igni�on for the Programming Func�ons
Verification:
The primary igni�on wire registers 12-Volt (+) when the vehicle is in igni�on mode AND during engine crank.
5. PURPLE – Accessory Output (+)
At its default setting, the PURPLE wire supplies 12-Volt (+) to the vehicle’s accessory wire to power vehicle accessories
during remote start.
Verification:
The accessory wire registers 12-Volt (+) when the vehicle is running or in Accessory mode, but not during
engine crank or if the vehicle is off.
Note:
This wire can be programmed to perform a different func�on by changing its op�ons.
Refer to Bank 3, Feature 9
on page 10
.
