APS57TM_RevA_07/20
4
Detailed Descriptions:
Wire Harness Colors and Func�ons
Input / Output Connector (14-pin connector)
See page 22 for the full system diagram.
These wires are listed in order of their placement in the harness connector.
1
2
3
5
7
9 11 13
4
6
8 10 12 14
3. GRAY/BLACK – Hood Input (-)
The GRAY/BLACK wire connects to the vehicle's hood switch, or an installed switch that registers Ground (-) when
triggered.
Verification:
The vehicle hood switch wire registers Ground (-) when the hood is opened.
5. LIGHT BLUE – Remote Start Status Output (-)
The LIGHT BLUE wire supplies Ground (-) as soon as the remote starter is ac�vated and remains ac�ve un�l 4 seconds
a�er remote start run �me has ended. This wire is most commonly used to ac�vate data integra�on modules.
1. BLACK/WHITE – Horn Output (-)
The BLACK/WHITE wire connects to the vehicle's horn wire and supplies Ground (-) when ac�vated from the system.
Verification:
The vehicle horn wire registers Ground (-) when the horn is ac�vated.
9. BLACK/BLUE – Factory Disarm Output (-)
The BLACK/BLUE wire supplies a Ground (-) pulse when the system is disarmed and when remote start is ac�vated.
Verification:
In most vehicles the vehicle factory disarm wire registers Ground (-) if the driver door key cylinder is turned
to the unlock posi�on.
Note:
This wire can be programmed to perform a different func�on by changing its op�ons.
Refer to Bank 3, Feature 19
on page 10
.
7. BLACK/LIGHT GREEN – Factory Arm Output (-)
At its default setting, the BLACK/GREEN wire supplies a Ground (-) pulse when the system is armed and when the
vehicle has been successfully started using remote start. It is typically used to re-lock vehicle doors a�er remote start if
necessary.
Note:
This wire can be programmed to perform a different func�on by changing its op�ons.
Refer to Bank 3, Feature 21
on page 10
.
6. DARK BLUE/BLACK -- External Start Input (-)
The DARK BLUE/BLACK wire connects to a device or switch that, when triggered, supplies a Ground (-) output. If the
vehicle igni�on is off, this input will ac�vate the remote start func�on.
8. BROWN/BLACK – Brake Input (+)
The BROWN/BLACK wire connects to the vehicle's brake wire to supply brake status for remote start.
Verification:
The vehicle brake wire registers 12-Volts (+) when the brake is ac�vated.
2. RED – Door Lock (-)
The RED wire supplies Ground (-) when the Lock func�on is ac�vated from the remote control or system.
Verification:
The vehicle lock wire registers 12-Volts (+) or Ground (-) when the Lock bu�on is ac�vated. Addi�onal parts
may be required.
See Page 19 for common door lock wire diagrams.
4. GREEN – Door Unlock (-)
The GREEN wire supplies Ground (-) when the Unlock func�on is ac�vated from the remote control or system.
Verification:
The vehicle lock wire registers 12-Volt (+) or Ground (-) when the Unlock bu�on is ac�vated. Addi�onal parts
may be required.
See Page 19 for common door lock wire diagrams.
