128-9300
8 of 24
8
3 Green Wire: Door Unlock (-) Output
The Green wire provides a (-) Negative Pulse when the transmitter is used, while the vehicle is running by
remote start, to unlock the doors. See Page 12-13 for use of this unlock output.
4
Brown w/ Black trace Wire:
Positive Inhibit Input
The Brown w/ Black Trace wire provides an instant shutdown for the Remote Start Control module whenever
it gets + 12 volts. If the Brake lights switch in the vehicle sw 12 volts to the brake light circuit, con-
nect the Brown w/ Black trace wire to the output side of the brake switch. This will allow the Remote Start
to shut down if an attempt is made to operate the vehicle without the key while running under the control
of the Remote Start. In most vehicles, in order to shift into gear, the brake pedal must be depressed. The
brake input will in turn cause the remote start unit to shut off.
5 Brown Wire:
(+) Inhibit Shut Down
Any time + 12 Volts is applied to the Brown wire, the Remote Starter will be prevented from operating, even
if the signal is received from the transmitter. If there is a neutral start wire in the vehicle that sw 12
volts when the vehicle is in any gear other than Park or Neutral, this wire can be connected to that vehicle
wire to prevent starting while in gear.
6 Gray:
(-) Inhibit / Shut Down
Any time ground is applied to the Gray wire, the Remote Starter will be prevented from operating, even if
the signal is received from the transmitter. If there is a neutral start wire in the vehicle that switches ground
when the vehicle is in any gear other than Park or Neutral, this wire can be connected to that vehicle wire
to prevent starting while in gear.
If the vehicle you are working switches ground to the brake light circuit, this wire can be connected to the
output side of the brake switch. This will allow the Remote Start to shut down if an attempt is made to op-
erate the vehicle without the key while running under the control of the Remote Start. In most vehicles, in
order to shift into gear, the brake pedal must be depressed. The brake input will in turn cause the remote
start unit to shut off.
7 Black w/ Yellow trace Wire:
Ground Output During Start (Crank)
The Black w/ Yellow Trace wire will provide a 300 mA ground output while the starter output of the remote
start unit is active. This output can be used to activate the Crank Low/Bulb Test wire found in some GM
vehicles. This wire is also referred to as the ECM wake up wire in some vehicles.
NOTE:
The outputs above are low current outputs and must be used with a relay if the circuit's requirement
is more than 300 mA. This output is also selectable and can preform an alternate function as shown in
feature selection bank 3 Feature #20.
8 Black w/ Red trace Wire:
Pulsed Ground Output After Shutdown
The Black w/ Red Trace wire will provide a 1 second 300 mA pulsed ground output 2 seconds after the
remote starts GWR wire shuts down. This output will occur regardless of whether the circuit times out or is
manually terminated. Typically this output will be used to re-lock the vehicle doors if the doors unlock auto-
matically when the ignition circuit transitions to off. This output is selectable and can function as described
in feature selection of bank 3 feature #22.
Summary of Contents for APS-901E
Page 23: ...128 9300 23 of 24 23 NOTES...
