128-9315
7 of 20
Page 7
If the LED is flashing three times...pause...three times...pause...etc., then
an intrusion attempt was made through one of the vehicle’s doors.
These intrusion warning indicators are stored in the system’s memory and will only
be erased when the ignition key is turned on.
Push Button LED Receiver Valet/Programming Switch
The push button switch located on the windshield mount receiver allows you to
temporarily bypass all alarm functions, eliminating the need to hand your transmitter
to parking attendants or garage mechanics. When the system is in valet mode, all
alarm functions are bypassed, however the remote panic feature and remote door
locks will remain operational. To use the valet mode, the system must first be dis
-
armed either by using your keychain transmitter, or by activating your personalized
manual override code.
1. Enter the vehicle, and turn the ignition key to the on position.
2. Press and hold the switch until the LED turns on solid. The system will remain
in the valet mode.
3. To return to normal operation, press and release the switch any time the ig-
nition is on.
NOTE:
Always remember to return the vehicle to the valet off position. This will
ensure that the vehicle remains protected at all times.
MANUALLY OVERRIDING YOUR SYSTEM:
USING THE OVERRIDE SWITCH
Your Security System can be disarmed without the use of the keychain transmit-
ter. This is necessary, since you will need the ability to operate your vehicle if the
transmitter is lost or its battery fails. If your system has been selected for Valet
Switch manual override as indicated on the last page of this manual, to bypass the
alarm system;
1. Open the vehicle door. The alarm will sound.
2. Turn the ignition key to the on position.
3. Within 5 seconds, press and release the switch found on the windshield
mount receiver
