PRESSCON HORNIT N2, User Manual, Page: 60 / 71

60
7.3.3 Fault and alarm messages for the PRESS-Basic control(ECONOMY B)
This table of error and alarm messages is based on software version: BasicPControl V2.0
Alarm no. Display message Fault Alarm Description Cause of problem
F01 Eeprom address X
Read/write error in the
An error occurred while trying to
read 1 or
F02 Eeprom R/W X
permanent eeprom
Writing a setting; check the
configuration
F03 Eeprom address0 X
Memory settings
F04 Configuration X
Checksum error.
F05 CAN TxBuffer X
CAN-bus send buffer is full.
Check CAN-bus. Adjust macro
interval.
F06 CAN RxBuffer X
CAN-bus receive buffer is full. When necessary
F07 Config base X
Base values do not match. New software or first time starting
F08
program memory may be faulty
F09 First boot X
First time starting, new cfg.
F10
F11 CAN-bus halt
CAN-bus stop detected.
One of the devices on the bus
had a fatal CAN error, or has
been restarted
F12 x
F13 x
F14 Waterlevel min X X
Water below minimum level
Insufficient water in the heat
storage tank
F15 Waterlevel max X X
Water above maximum level Drain off water
F16 Water lower X
Water above reduce level Drain off water
F17 Water raise X
Water below reduce level Add water
F18 Systempress min X X
System pressure below
minimum level. System pressure not correct; call
service technician
F19 Systempress max X X
System pressure above
maximum level. there is a leakage on the system
or
F20
F21
F22 Main power
The system has restarted
F23 Comp thermic X X
Compressor thermal error Compressor error: Check
F24
compressor; call service
technician
F25 Comp air low X X
Compressor pressure too low
F26
F27
F28 Uart1 rxFifo X
UART1 receive buffer is full
Too much debut information sent
or line noise