PRESSCON HORNIT N2, User Manual, Page: 46 / 71

46
5. PRESS-display
The PRESS-display is the monitoring device for reading the statuses and measured values of the system. The buttons
are used to navigate and adjust the settings. Figure 23. Below shows a schematic view of the PRESS-display.
Figure 23. Schematic view of Press-display
5.1 Buttons on the PRESS-display
Each button has a different function, some have more than one. The following table describes which function each button
has.
Button Description
This button has a light beneath it, when it lights up, this means the following:
Light on
: An error or alarm has been detected;
Light flashes: There is a new error or a new alarm.
With this button, you can reset an error or alarm message as soon as the problem that caused the
message has been solved.
Press the button once to view the current errors and alarm messages.
Press and hold for 3 seconds to view the error and alarm log.
From the main screen:
Press the button once to enter the Service menu. An access code is required.
Press and hold for 3 seconds to view the factory menu. An access code is required.
Adjusting a setting in one of the menus:
In the user menu: press and hold this button for 3 seconds. The setting will flash and is then
adjustable.
In the service menu and factory menu: press this button once briefly. The setting will flash and is
then adjustable.
Press this button once briefly to view the service information screen.
Press and hold for 3 seconds to view the factory information screen.
Press this button once briefly, in one of the menus or information screens, to go back one screen
and then return to the main screen.
Press this button once briefly while adjusting a setting. The adjustment will be cancelled.
Press this button once briefly in one of the menus to select the next screen.
Press this button when setting a value to increase the value.
Press this button once briefly in one of the menus to select the previous screen.
Press this button when setting a value to decrease the value.
Info Prog Esc
+
-
Reset
Alarm
PRESSCON
Netherlands
Scherm
(LCD display)
Knoppen
(toetsenbord
en start/stop
knop)
Reset
Alarm
Prog
Info
Esc