PRESONUS FIRESTUDIO MOBILE - SCHEMA, User Manual

Page: 37 / 51

CONTROLS AND CONNECTIONS
35
| PreSonus 2008
3.3.3 Output Faders
At the bottom of the Outputs/Router tab, you will see all of your physical outputs enumerated (Analog 1 through
S/PDIF R). Each output is visually represented as a fader on a traditional console.

Channel fader
The fader controls the volume of the signal on any given output. The signal
is metered realtime directly to the right of the fader

Realtime decibel readout
Above the meter on each channel strip, you will see a number. This is the dB
level of the signal being routed to that ouput

Fader attenuation
Below the meter, you will see the fader attenuation (-96 to 0dB). OdB is
unity and is achieved by raising the fader all the way up. -96dB represents
the fader at its lowest position.

Clip indicator
Each meter is equipped with a clip indicator to alert you should your levels
get too hot. A red “C” will illuminate when the track has clipped and will
remain illuminated until it has been reset. To reset the meter, simply click on
the “C”.

Stereo link
The Link button joins outputs into stereo pairs. To enable this, simply click
on the word “LINK”. The letters will turn blue. To separate the channels,
click the word again. When channels are linked, the volume of both will be
controlled with either fader.

Mute
The Mute button cuts all signal coming from the specified output. If the
channels are linked, muting either of the channels will mute both.