7
CONGLOMKB .COM
Please contact customer .service@conglomkb .com or 1-877-333-0098 for further assistance .
Installation (continued)
DRILLING THE HOLES FOR THE UNDERMOUNT
CLIPS
1
4
5
2
3
CAUTION:
Always wear safety goggles and gloves when
using power tools to prevent personal injury .
- On the underside of the counter, mark the location of the
ten holes (5) for the undermount clips (J) . These holes
should be equally spaced around the perimeter of the cut-
out with three on each side 2 and 4 and two on each side
1 and 3 . They should be set back from the cut-out opening
by 1 1/4 in . (32 mm) .
- Using an electric drill with a 3/8 in . (10 mm) drill bit, drill
each hole so that it is 3/8 in . (10 mm) in diameter and 5/8
in . (15 .8 mm) deep .
TESTING THE FIT OF THE SINK
- Place the sink (A) underneath the cut-out in the counter to
test its fit. Ensure that the reveal is equal on sides 1 and
3 when viewed from above . There should also be at least
4/10 in . (11 mm) of deck revealed on side 2 to accomodate
the slide of the cutting board (E) . Make adjustments to the
cutout if necessary .
-
When you are satisfied with the location of the sink (A),
mark the location of the edge of the counter cut-out on at
least two sides of the lip of the sink .
11 mm
Counter
Cutting Board
Faucet hole
A
1
2
4
3
