8
Section 3 - INSTALLATION
© Copyright 2006 PREO SRL
All rights reserved
EAW530E2MV
Edition
03/2006
3.2 INSTALLATION REQUIREMENTS
Before installing the applicator, make sure that the necessary environmental
conditions and services are in place.
Figure 6 illustrates the minimum area necessary for correct installation and ideal
system operation.
Figure 6
You should also take the following additional factors into consideration before
proceeding with installation.
•
Install the system in environments with a temperature between –5°C and
+50°C.
•
Install the system well away from areas subject to strong draughts or
repeated changes in temperature.
•
Install the system in such a way that the operator is able to access all the
controls in complete safety.
•
Avoid positioning the system on surfaces subject to strong vibrations.
•
Always avoid contact with water, inasmuch as the applicators are not
watertight.
3.3 CHECKING YOUR PURCHASE
Before installation, make sure that the machine has not been damaged during
transport or by storage conditions.
Also make sure that all the optionals ordered and all the equipment supplied as
standard are included in the packaging.
The hot-melt unit is supplied by the factory with an installation kit containing
components that the client should install on the applicator.
The client will need additional materials to complete the installation.
3.4 REMOVING THE PACKAGING
Before installation, remove the applicator from the relative packaging.
Hoses, guns and any accessories are supplied loose from the applicator and
packaged in bags or boxes inside the packaging.
