Premier Pet GDT00-16301, Product Manual

Page: 4 / 8

+1 (866) 381-2785 4
Fit the Collar
Important: The proper fit and placement of your Training Collar collar is important for
effective operation.
1. Start with the collar turned off and your dog standing
comfortably, not sitting.
2. Place the collar on your pet so that the Premier Pet
™
logo is right
side up and the collar is directly under your dog’s chin. Center
the contact points underneath your dog’s neck, touching the
skin.
NOTE: It is sometimes necessary to trim the hair around the
contact points to make sure that contact is consistent.
3. Check the tightness of the collar by inserting one finger between
the end of a contact point and your dog’s neck. The fit should be
snug but not constricting.
4. Allow your dog to wear the collar for several minutes, then
recheck the fit. Check the fit again as your dog becomes more
comfortable with the collar.
Do not shave the pet’s neck as this may increase the risk of skin irritation. The collar should not be worn for more
than 12 hours out of every 24-hour period. Leaving the collar on too long could lead to skin irritation.
Charge the Collar and Remote
Excessive charging can shorten battery life. Only charge your remote or collar when the batteries are low.
1. Lift the cover protecting the charging port and connect the charger to the collar and/or remote.
2. Plug the opposite end of the charger into a compatible charging port.
3. Fully charge the training collar and the remote. The indicator light on the remote and the training
collar will turn solid green after 12 hours of charging. For the first charge, continue to charge them for
an additional 12 hours.
4. When the training collar and remote are charged, replace their rubber covers.
Turn the Collar On/Off
To Turn the Collar On
1. Press and hold the On/Off button until the collar LED is solid green and beeps low to high.
2. Release the On/Off Button. The collar LED will flash green once every 5 seconds. The flashing light
indicates the training collar is on and ready to signal from the remote.
To Turn the Collar Off
1. Press and hold the On/Off Button until the LED light is solid red and the collar beeps high to low.
2. Release the On/Off Button.
Quick Tip: When you are not using the collar, you will want to turn it off. This will increase the battery life.
NOTE: The remote is always on and will communicate when any button is pressed.
Test the Collar
To test the collar, ensure that the remote is paired with the training
collar. Press the test light tool against the contact points on the collar.
Push the stimulation button on the remote. The test light will flash.