Page 8
Installation Instructions
PSD-TL
Optional Installations
Floor Installation
Step 1
. If securing the base to the floor, use
(commercially available) hardware.
Step 1
. The shelf must be attached before the flat-panel
and PSD-SPA adapter is installed to the
stand.
Step 2
. Attach the shelf to the poles by sliding the shelf
over the poles and down into position.
Step 3
. Determine the final height and secure the shelf
using four (4) M8 x 10mm set screws.
Step 4
. Tighten these screws using the supplied Allen
wrench.
Do not install the optional shelf higher than
39”.
If using a shelf, please install prior to
attaching the flat-panel.
Suitable Hardware
(Commercially Available)
Shelf Installation
Optional
Shelf
M8 x 10mm
Set Screws
Allen Wrench
DO NOT load the Stand past the maximum
weight capacity. Failure to comply with this
warning may result in Stand instability
leading to equipment damage or personal
injury.
WARNING
PSD-TL Base
(facing forward)
PSD-TL Base
(not facing forward)
