Installation
Instructions
Page
5
PSD-TL
Support Pole Installation
Remove the stand out of the box and check for all proper hardware, if missing any hardware please call Premier Mounts.
A mount is required to complete the PSD-TL system. Refer to the mount’s installation instructions to install the mounting
bracket.
Step 1
. Insert the poles inside the base columns of the
PSD-TL, making sure they are fully seated on
the base with the cable access holes facing the
rear of the base.
Step 2
. Secure the support poles by inserting and
tightening the four (4) M8 x 10mm locking set
screws that are located on the back of the
mounting
columns.
Step 3
. Tighten set screw with the supplied Allen
wrench. Do not over tighten the screws.
Step 1
. Install the PSD-SPA (mount adapter) over the top
of the support poles and secure it at the desired
height with the four (4) M8 x 10 set screws
(supplied).
Step 2
. Use the Allen wrench (supplied) to secure the
adapter to the support poles.
Adapter Installation
PSD-SPA Adapter
(facing forward)
Allen Wrench
M8 x 10mm
Set Screws
Support Poles
2” Diameter Support Poles
Allen Wrench
Mounting Columns
PSD-TL
Mounting Screws
The PSD-SPA adapter is used with the CTM and
PSM Series mounts only. The PSD-SPA is not
needed when installing the USA, UFA or
RTM-L/S mounts.
Please see Page 8 for optional shelf installation instructions.
The PSD-SPA must be facing forward when
mounted to the support poles.
