CTM-MS2
Installation Instructions
Visit the Premier Mounts website at http://www.premiermounts.com
Page 11
Safety Knurl Knob Installation
The safety knurl knobs keep the flat panel from
being accidently dislodged from the CTM-MS2.
➊
Fully extend the flat panel away from the wall.
➋
Install and tighten a safety knurl knob at the top of
one of the mounting brackets.
➌
Repeat steps 1 and 2 for the other safety knurl
knob.
Safety Knurl Knob
(1 per Bracket)
Panelock™ Installation
Panelock
™
Hook
Security Head
Wrench
M6 x 12mm
Security Head
Screw
Panelock
™
Hook
Security Head
Wrench
If you chose not to install the safety knurl knobs
and instead chose to use the Panelock
™
, skip this
section and proceed to the Panelock
™
Installation
section below.
The Panelock
™
is a theft deterent device. It comes
with security hardware that requires a special tool
that is used to install and remove the security head
screws.
If the safety knurl knobs were previously installed,
they must be removed prior to installing the
Panelock™ hardware.
➊
Slide the Panelock™ onto the top mounting rail,
placing the Panelock™ to the outside edge of the
flat panel bracket.
Be sure that the Panelock™ is facing in the same
direction as shown in the illustration to the right.
➋
Insert and tighten one (1) M6 x 12mm screw to
attach the Panelock™ to the flat panel bracket.
Repeat and to attach the remaining
Panelock™.
Proceed to “Tilt Adjustment” on page 12.
