Installation
Instructions
Page
7
PSD-TL
USA, UFA and RTM-L/S Installations
The USA, UFA, RTM-L and RTM-S Series of stand/cart mounts attach to the PSD-TL without the use of the PSD-SPA.
Please follow the installation instructions that are packaged with these mounts.
Step 1
. Slide the USA, UFA, RTM-L and RTM-S Series over and onto the support poles.
Step 2
. Determine the desired height.
Step 3
. Tighten the set screws, located at the rear of each mount, using the supplied Allen wrench.
Step 1
. For the PSM-Series, secure the back plate to the four (4)
threaded mounting points found on the PSD-SPA with the
four (4) M10 x 12 bolts and flat washers (supplied).
Installing the PSM
Support Poles
PSD-SPA Adapter
Directional Arrow
PSM Back Plate
M10 x 12mm
Bolts
M10 Flat Washers
Step 2
. Raise the flat-panel display with the mounting bracket
secured and insert the four (4) tab openings from the PSM
mount to the four (4) receiving tabs found on the back
plate.
Step 3
. Push the flat-panel display down, right and down again to
lock the mount together.
Step 4
. Make sure all tab openings are interlocked with the
receiving tabs before letting go of the flat-panel.
Step 5
. Secure the brackets with two (2) M6 x 12mm Phillips
(supplied with the PSM mount) screws for additional
security.
PSM Back Plate
PSM Mounting
Bracket
Flat-Panel
M6 x 12mm
Screws
PSD-TL Base
(facing forward)
PSD-TL Base
(facing forward)
