![background image](http://html1.mh-extra.com/html/premier-mounts/prf/prf_installation-instructions-manual_1596387007.webp)
PRF
Installation Instructions
Page 7
Place the wall plate against the wall, placing the upper
mounting hole over the hole that was drilled.
Level the wall plate and mark the lower mounting point.
Once the wall plate is level and the second mounting
location has been marked, drill the second pilot hole
using a
1
/
8
˝
drill bit and power drill.
Step 4
Solid Surface
Step 1
Installing the PRF Mount (cont’d)
Step 5
#10 x 2” Screw
Level
Wall Plate
Pilot Hole
Second Mark
All electrical wiring should be done prior to mount
installation. You may use the optional two (2)
6-32x1” Phillips head screws to secure a standard
electrical handibox to the mount.
Secure the wall plate to the center of the wood stud by
using two (2) #10 x 2” wood screws.
Do not over-tighten the mounting screws.
Determine the desired viewing location.
Solid Surface
Mark
Level
Wall Plate
Place the mount into position against the wall and
level the mount.
Mark four outer holes used to secure the mount.
When determining viewing height, the center of
the fl at panel should be at eye level while sitting
in an upright position. When using the fl at panel
as room decoration, raise it to the point where the
bottom of the screen is at eye level while
sitting and the top is eye level when standing.
Solid surface mounting requires the use of four (4)
outer mounting points on the wall plate.
Solid Surface Holes
Solid Surface Holes