PRF
Page 10
Installation Instructions
VESA 75/100 Installation
Step 1
Lift the fl at panel with the cover plate attached.
Place the mounting slot opening over the mounting tab
(on the wall plate).
Slide the fl at panel down slowly, ensuring that the
mounting slot is engaged by the mounting tab.
Step 2
Use a screwdriver to tighten the two (2) M6 x 12mm
securing screws.
This will lock the cover plate and wall plate securely
together.
Do not over-tighten these screws.
Locate the mounting points on the back of the fl at panel.
Secure the cover plate to the fl at panel using four (4)
M4 x 10mm screws.
Step 1
The slotted opening must be facing up and the fl at
surface touching the fl at panel surface.
Do not over-tighten the mounting screws.
Cover Plate
Securing Screw
(Pre-Installed)
Mounting Point
Flat Panel
Slotted Opening
M4 x 10mm Screw
If you have a recessed VESA 75mm/100mm
pattern or need more spacing between the wall
and the fl at panel, use the appropriate number of
universal spacers and corresponding length
mounting hardware. If your mounting pattern is not
75/100, proceed to page 11.
Attaching the Front Cover to the Wall Plate
Mounting
Slot
Mounting
Tab
Flat Panel
Do not release the fl at panel until verifying the
connection between the mounting slot and the
mounting tab.
M6 x 12mm
Securing
Screw
Screwdriver
If your fl at panel has a 200mm x 100mm or
200mm x 200mm mounting pattern, the VESA
Adapter Plate must be used. Please refer to the
VESA Adapter Plate Pattern to determine the
appropriate mount placement.
