How to put on the full body harness
Prior to each use, a visual inspection of the full body harness must be carried out in order to ensure its impeccable
condition. Particular attention should be made regarding the following: cuts, wear, damage due to heat, chemicals and
similar, undamaged seams and fittings (no corrosion, no mechanical deformation or cuts as well as inspection regarding
impeccable function). Check the impeccable function of the karabiners as per EN 362 which are included in the scope of
supply of the full body harness, i.e. snap safety catch closes without problem and clicks in completely, the locking screw
element can be operated smoothly and correctly, self-locking twist fasteners and Trilock fasteners latch in completely as
envisaged and lock impeccably.
All fasteners are free from any contamination which might impair their function.
Damaged full body harnesses must not be used, also not when there are doubts regarding their safe condition
Î
pass on
to a competent person or to the manufacturer for inspection (address see page 1 of these instructions for use)!
Only use original parts made by Preising!
A full body harness which has been used for an arrest fall, must be immediately put out of service and sent to the
manufacturer for inspection (address see page 1 of these instructions for use)!
Your full body harness is supplied with the following documentation:
1. Identity card indicating manufacturer, serial number, model, date of being put into service (to be filled in by the user) etc.
2. These instructions for use.
Both documents must be stored carefully and should be available at all time.
Alternative solutions are within the responsibility of the company.
Remove the full body harness from
the packaging, hold it at the shoulder
straps so that the harness is
completely spread out.
Open the leg straps amd put on
the full body harness by placing
the shoulder straps over the
shoulders as shown
Fix the full body harness by
closing first the front chest
buckle (if available for the
respective model).
Then close the leg straps.
And finally the waist belt.
If your model is equipped with a fall arrest
attachment element on the front, both belt loops
must be connected using a karabiner as per EN
362. Make sure that the snap safety catch has
been closed according to the instructions!
