Page 8
For technical questions, please call 1-888-866-5797.
ITEM 63078
SAFETY
Op
ERA
TION
M
AINTENANCE
SETU
p
Set Up
Read the ENTIRE IMpORTANT SAFETY INFORMATION section at the beginning of this manual
including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURY: Operate only with proper spark arrestor installed.
Operation of this equipment may create sparks that can start fires around dry vegetation.
A spark arrestor may be required.
The operator should contact local fire agencies for laws or regulations
relating to fire prevention requirements.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Components and Controls
GROUND
IF ANY CIRCUIT BREAKERS TRIP ENSURE THAT ALL CIRCUIT BREAKERS ARE RESET
LOW OIL
START
ENGINE SWITCH
OFF
ON
CHOKE
Pull at Start.
Push when Running.
GFCI
RECEPTACLES
WILL NOT
PROTECT
AGAINST
ELECTRIC
SHOCK IF
GENERATOR IS
NOT GROUNDED
HC = Current
Hours
HT = Total
Hours
V = Voltage
Hz = Hertz
1.
UNPLUG DEVICES
2.
RESET ALL CIRCUIT BREAKERS
3.
MAKE SURE DEVICE AMPS ARE LESS THAN 92 TOTAL (120VAC)
Display
Switch
Choke Knob
120 / 240VAC
46 A Breakers
Low Oil Indicator
120 / 240 VAC 46 A
Receptacle
120 / 240 VAC
30 A Receptacle
and Breakers
120 VAC 30 A
Receptacle
and Breaker
120 VAC 20 A
GFCI Receptacles
and Breaker
120 VAC 20 A
GFCI Receptacles
and Breaker
Ground
Terminal
12 VDC Receptacle
and Breaker
Figure A: Control panel