Page 16
For equipment technical questions, please call 1-888-866-5797.
ITEM 62214
SAFETY
SETUP
O
PERA
TION
M
AINTENANCE
Stopping the Engine and Pressure Washer
1. To stop the engine in an emergency,
turn the Engine Switch off.
2. Under normal conditions, use the following procedure:
a. Release the Trigger on the Spray Gun handle.
b. Turn the Engine Switch off.
c. Close the Fuel Valve.
d. Turn the water supply off.
3. Squeeze the Trigger to release excess pressure.
4. If pressure washer detergent has been used,
run clean water through the system to eliminate
detergent residue using the following procedure:
a. Turn off the Engine as detailed in step 2.
b. Fill the Detergent Tank with clean water.
c. Remove the Nozzle and restart the
Engine following directions in
Starting
the Engine
on page 13.
d. Point Wand in safe direction and hold down
Trigger to flush water through system until clean.
e. Turn off the Engine as detailed in step 2.
Folding and Storing
1. Disconnect the water supply hose from the
water inlet connection on the Pump.
2. Drain all water out of the Pressure Washer and lock
the Trigger. Clean external parts with clean cloth.
3. Disconnect the Pressure Hose from the Pump
and Spray Gun, drain water from Hose and coil.
4. Loosen the nut and remove the
Wand from the Spray Gun.
5. Loosen Handle Knobs, fold Handle forward to a
horizontal position and tighten the Handle Knobs.
6. Clip the Wand into the Wand Holders
and hang the Spray Gun from the Spray
Gun Holder as shown in Figure G.
7. Store the equipment indoors out of children’s reach.
Spray Gun
Wand
Handle
Handle Knobs
Figure G
NOTICE
Drain fuel at end of season or warranty is void.
See Long-Term Storage on page 20 for complete storage instructions.
O
I
OFF
