Page 13
For equipment technical questions, please call 1-888-866-5797.
ITEM 62214
SAFETY
SETUP
O
PERA
TION
M
AINTENANCE
Starting the Engine
Before Starting the Engine
a.
Inspect the equipment and engine.
b.
Fill the engine with the proper amount and type of both unleaded gasoline and oil.
c.
TURN ON WATER SUPPLY, REMOVE NOZZLE, POINT WAND IN SAFE DIRECTION, AND HOLD
DOWN TRIGGER UNTIL ALL AIR IS RELEASED FROM THE SYSTEM, AT LEAST 30 SECONDS.
Then release the Trigger, lock it in the safety position and replace Nozzle before starting engine.
Manual Start
1. To start a cold engine, move the Choke to the
START position.
To restart a warm engine, leave the
Choke in the RUN position.
2. Open the Fuel Valve.
3. Turn the Engine Switch on.
Note:
If engine does not start, check engine oil.
Engine will not start with low or no engine oil.
4. Grip the Starter Handle of the Engine loosely and pull
it slowly two times to allow the gasoline to flow into
the Engine’s carburetor. Then pull the Starter Handle
gently until resistance is felt. Allow Cable to retract fully
and then pull it quickly. Repeat until the engine starts.
Note:
Do not let the Starter Handle snap back against the engine.
Hold it as it recoils so it doesn't hit the engine.
1
2
ON
OFF
O
I
ON
3
4
