Vitality Series Selectorized Line Abdominal / Back Extension Assembly Guide: Assemble the Equipment
14
Install the Weight Stack Shrouds and the Top Cap
Note:
The inside shroud has a slot for weight selection. Both shrouds have two
slotted tabs on each side that fit into the shroud clips mounted to the inside of
the weight tower uprights.
1.
Align the slotted tabs on the inside shroud with the shroud clips on both
sides of the weight tower.
2.
Press the hooks into the clips and lower the shroud securely into place.
3.
Repeat steps 1 and 2 to install the outside shroud.
4. Place the top cap on top
of the shrouds so that the top edges of the
shrouds fit
into the slot between the lip and the ribs of the top cap. Secure
the top cap to
the weight tower frame using
:
4 – M6 x 12 mm button head bolts
4 – 7 mm flat washers
Note:
When you secure the top cap, if the top edges of the shrouds do not fit
securely into the slot between its lip and ribs, remove the cap and the shrouds.
Loosen the fasteners securing each of the shroud clips, then secure each clip
again so that it is mounted
as high on the weight stack frame as possible
. You will
need to push the clips up and hold them in place while you secure them. After
you have repositioned all of the shroud clips, repeat this procedure to install the
shrouds and the top cap.
Figure 17: Weight stack shroud and top cap assembly
Summary of Contents for Vitality Selectorized C028ES
