© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 53
9
Remove the flat ribbon cable.
10
Remove the Philips screws from the underside of the heart rate grips on the left handlebar. Lift the
grips from the handlebar and disconnect the wire from both grips. Repeat this procedure on the
right handlebar.
11
Remove the heart rate cable from the seat carriage.
Installing the Heart Rate Cables
12
Feed the replacement heart rate cable into the access hole on the underside of the seat carriage.
13
On both the right and left handlebars, feed the white wire out of the upper heart rate grip access
hole and the black wire out of the lower heart rate grip access hole.
14
On both handlebars, connect the upper heart rate grip to the white wire and the lower handlebar
grip to the black wire. Replace the screws and fully tighten.
15
Connect the flat ribbon cable to the heart rate cable and replace the cable cover.Replace the screw
and fully tighten.
Replacing a Seat Carriage Wheel
1
Remove the 14mm lock nut and washer from the wheel being replaced, remove the 14mm shoulder
bolt and wheel
Figure 54: Cable Cover - Seat Carriage Bottom
Summary of Contents for UBK13
Page 2: ......
