© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Page 31
Installing a Crankarm
16
Place the crankarm onto the crankarm axle; ensure the crankarm is positioned 180° opposite the
other crankarm.
17
Thread the crankarm mounting bolt into the crankarm axle and fully tighten.
18
Install the pedal to the crankarm.
Pedal the bike for one minute and then re-tighten the crankarm mounting
bolt.Installing the Primary Drive Belt
19
Place the primary drive belt in its mounting position around the input pulley, under the idler pulley
and around the primary pulley.
20
Tension the primary drive belt as per procedure,
Primary Belt Tension Adjustment
(on page 9).
21
Replace the covers as per procedure,
Replacing the Covers - UBK13
(on page 16) or
Replacing the
Covers - RBK13
(on page 21).
Replacing the Input Pulley and
Axle Assembly
1
Remove the covers as per procedure,
Replacing the Covers - RBK13
(on page 21) or
Replacing the
Covers - UBK13
(on page 16).
2
Remove the left hand crankarm and pedal.
Figure 21: Crankarm Position
Summary of Contents for UBK13
Page 2: ......