©2019 Precor Inc. | Lateral Raise RSL 504 | Assembly Guide
10
Route the Cable
Image
Hardware
Instructions
1
Tools: Hex wrench, 8 mm
Socket wrench, 16 mm
Remove cable retainers from both cams.
2
Route cables around cams and replace retainers.
3
2 shafts, small
2 retaining rings, 8 mm
Tool: Retaining ring pliers
Secure cables to designated holes on cams. Slide the clevis pins over holes, insert
shafts and secure with retaining rings.
4
Tools: Hex wrench, 8 mm
Hex wrench, 4 mm
To route the cable around the lower pulley on the weight stack tower, remove
the cable retainer. Route the cable around the pulley and then replace the cable
retainer.
5
Tools: Hex wrench, 8 mm
Open-end wrench, 19 mm
Torque wrench
To route the cable to the upper pulleys of weight stack tower, remove the cable
retainers, route the cables, and replace the retainers.
Tighten to 50 ft-lb (67
N-m) of torque.
43
36
43
36