Precor RBK 800-Series, Assembling And Maintaining Manual

Page: 19 / 100

Assembling the Exercise Bike
17
To attach the bottle holder:
1. Position the bottle holder so that it wraps around the seat
back assembly and rests on the tab on the back of the
assembly. The front edges of the bottle holder should rest
on the handlebars and the two snap-in tabs should line up
with the small rectangular holes on the seat back
assembly.
2. Press the bottle holder forward until it locks into place.
Installing the Upright Support and Cables
DANGER
Do not attempt to connect electrical power until all
assembly procedures are complete and the console
is properly installed.
Before you begin this procedure, retrieve the cables for the
console that you plan to install on this exercise bike. The
cables are packed with the console.
Note: You will need the help of another person while
performing the procedure.
To prepare the bike for installation of the upright support:
1. Retrieve the cables from the box in which the console was
shipped.
2. Using a #2 Phillips screwdriver, remove the two #10 x
1-inch self-tapping screws holding the top cover in place,
then lift it off. Lift the cover from its front edge first, then
disengage its plastic tabs from the recesses on the rear
cover into which they fit.
Figure 3: Top cover removal