Rewire the Upright Bike
NOTE
You need to remove only one side cover to thread the cables.
To thread the new cables through the equipment:
Step
Procedure
Use a #2 Phillips screwdriver to remove the two self-tapping screws
holding the rear cover in place. Pull the upright rear cover back to
remove it.
Remove the two self-tapping screws holding the top cover in place.
Slide up the rubber seal and then lift off the cover.
Remove the four self-tapping screws holding the left side cover in
place, then pull the cover away from the body assembly. Guide the
cover around the pedal crank, then remove it.
Remove blank jack panel at base of bike and feed the cables down
the mast.
The cables need to be threaded around the bolts that hold the center
mast in place.
Guide the ends of each cable through the gap at the bottom of the
center column. Remove the CAT5 (Ethernet) coupler from the square
hole in the jack panel, then feed the cables through the hole.
Important The cables must be secured in the cable retainers along the
frame and then exit the square hole in the jack panel. You may need to
slide out the jack panel to remove the CAT5 coupler and feed the cables
through the hole. If so, return the jack panel to its previous position when
you are finished.
N/A
Reattach the bike covers.
2
1
1