Precor C952, Service Manual

Page: 90 / 153

17. Align the bottom plate and pivot bracket holes with the running deck bolt holes. Replace
the roller guard, install and hand tighten the deck mounting bolts.
18. Verify that the spacing on all four corners is the same, adjust as necessary.
19. Check the alignment of the magnet and the auto stop assembly, see "Auto Stop Sensor
Replacement" on page 51 .
20. Tighten and torque the Deck mounting bolts to 150 in-lbs (17 N-m).
21. Reinstall the Drive Roller and Drive Belt, see "Drive Roller Replacement" on page 62 .
22. Reinstall the Take-Up roller, see "Take-Up roller Replacement" on page 86 .
23. Tension and verify the running belt tracking, see "Running Belt Tension and Tracking
Adjustment" on page 45 .
24. Replace the belt guard cover ensuring the tabs are firmly locked into position on the
Take-Up roller shaft, see "End Cap & Belt Guard Cover Replacement" on page 66 .
25. Replace the end cap, see "End Cap & Belt Guard Cover Replacement" on page 66 .
New Deck break-in
26. Straddle the running belt and set the speed to 3 mph (5 kph). While holding the treadmill
handles, walk onto the middle of the running belt starting from the back walking to the
front and returning to the back. Repeat walking process 4 times.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions. Page 83
6 Replacement Procedures
Running Belt and Deck Replacement