917, 917si Treadmillr
Page 26
Procedure 6.1 - Replacing the Running Bed
1.
Set the circuit breaker in the “off” position and remove the line cord from the AC outlet.
2.
Remove the four screws that retain the hood. Remove the hood by pulling the from the sides
and back slightly.
3.
Remove both endcaps and the take up roller.
4.
Unsnap both of the running bed trim strips from the running bed.
5.
Remove the screws that fasten the rear of the running bed to the treadmill frame.
6.
Lift the running bed straight up and two inches to the rear, to clear the drive roller pulley.
Slide the running bed out of the running belt taking care not to scratch the treadmill frame
with the belt trackers that are fastened to the bottom front of the running bed.
Diagram 6.1 - Running Bed
7.
Remove the belt trackers from the old running bed and mount them on the replacement
running bed. Set the replacement running bed in place in the treadmill, again taking care not
to scratch the treadmill frame as the running bed is slid into place.
8.
Replace the running bed and partially tighten mounting screws removed in step 5. Center
the running bed between the treadmill frame rails and securely tighten the running bed
mounting screws.
9.
Replace the take up roller and end caps.
End Cap
Running Belt
Trim Strip
Targa
Left Side Cover
Hood
