© 2020 Precision Lighting Ltd. We reserve the right to change details of design, materials and finish. Version 11.20
1.
NOTE
Model shown is the Solo 16 LED.
The same procedures apply for Solo 11
LED.
2.
3.
1. Installing the luminaire
Drill the pilot holes and the wiring hole
(See drilling template).
Tilt luminaire 90 degrees to expose holes
for screws. Use a screwdriver to tighten
screws into place.
2. Locking Pan
NOTE
Only adjust luminaire position
when unlocked.
Tilt luminaire 90 degrees to expose pan
hole. Adjust luminaire to desired pan
position. To lock into place, insert hex key
provided into pan hole then rotate hex
key clockwise.
3. Removing and changing the snoot
CAUTION
the luminaire may be
extremely hot. Allow to cool before
touching.
Unscrew snoot anti-clockwise to remove.
To reattach snoot, align snoot with thread
and screw on clockwise until it stops and
is secure.
4. Changing the microlens
Follow step 3 to remove the snoot.
NOTE
Ensure the microlens is inserted
with smooth side / text facing outwards,
and is readable.
Unscrew the microlens cap anti-clockwise
until fully detached. Remove the microlens
and replace with alternative microlens
ensuring it is installed flat.
Reattach microlens cap, screw clockwise
until it stops and is tight and secure.
To reattach snoot, align snoot with thread
and screw on clockwise until it stops and
is secure.
