© 2020 Precision Lighting Ltd. We reserve the right to change details of design, materials and finish. Version 11.20
33
These instructions are applicable to all
luminaires including:
Solo 11 - Surface
Solo 16 - Surface
Solo 16 Plus - Surface
WARNING
Do not exceed maximum number of
luminaires per driver wattage rating, see
driver datasheet for details.
Remote access required for driver.
WARNING
mains supply to driver must
be OFF before connecting or disconnecting
fittings. Do not connect or disconnect
under load.
Ensure driver has not been powered for a
minimum of 1 minute before reconnecting
the LED module after disconnecting.
Do not hot plug. Failure to follow this
WARNING
1-2 luminaires per DRIVER
WARNING
1-2 luminaires per DRIVER
instruction will lead to serious damage
of the LED module and driver and will
not be covered by warranty.
NOTE
Wire specification: 22 AWG,
ø0.65mm diameter double insulated
teflon wire.
Red - Positive
Black - Negativ
e
1. Connect Solo luminaires in series to
the driver LED outlet.
Maintain correct polarity when wiring.
Incorrect wiring will cause serious
damage and will not be covered by
warranty. Must be installed according to
SELV regulations.
2. Wire 1-10V or DALI control to LED
driver.
Maintain correct polarity when wiring
dimming control wire. Incorrect wiring
will cause serious damage and will
not be covered by warranty. Must be
installed according to SELV regulations.
1. All systems must be installed by a suitably
qualified professional only. Installations
must conform to national installation
and accident prevention regulations.
2. Ensure that the luminaire is switched off at
mains supply before installing or removing.
3. Do not install these systems in a damp
or wet location, IP20 environments
only. Do not install any fixture closer
than 150mm (6 inches) from any
combustible material.
4. To reduce the risk of fire and burns, do
not install these systems where exposed
bare conductors can be shorted or
contact any conductive materials. Do not
conceal or extend exposed conductors
through a building wall.
5. Ensure all connections are tight. Bad
connections can cause overheating,
arcing and a potential fire risk.
6. Wire supply connections must be made
with U.L or compatible testing agency-
approved connectors.
Always use
appropriate optics and ensure they are
fitted securely.
7. Install and use only as described in this
Precision Lighting manual.
8. Use Precision Lighting recommended
optics and accessories only.
9. Luminaires may be hot, allow to cool
before touching.
10. Access to serviceable electrical
components should be kept available
for maintenance purposes.
11. Regular cleaning of these products is
important. Switch off at mains supply
and allow to cool before touching.
Clean fittings with a microfibre cloth.
Then reconnect the power supply.
instruction manual
Solo 11 / 16 / 16 Plus Surface
Electrical Installation
350mA (11 series) or 700mA
(16 series) Constant Current
Driver.
1 -10V
/ DALI
1 -10V
/ DALI
MAINS
MAINS
350mA Constant
Current Driver
Output /
Secondary
Output /
Secondary
Solo 11 Surface
Solo 16 & 16 Plus
Surface
700mA Constant
Current Driver
