© 2017 Precision Lighting Ltd. We reserve the right to change details of design, materials and finish. Version 02.17
WARNING
Do not connect or disconnect under load.
Ensure driver has not been powered for a minimum of 1 minute before reconnecting the
LED module after disconnecting. Do not hot plug. Failure to follow this instruction will lead to
serious damage of the LED module and driver and will not be covered by warranty.
NOTE
LED module is not site serviceable.
Tampering will cause damage and will not
be covered by warranty.
NOTE
Maintain correct polarity when wiring. Incorrect wiring will cause serious damage and
will not be covered by warranty. Must be installed according to SELV regulations.
Wire specification: 22 AWG, ø0.65mm diameter double insulated teflon wire.
White - Positive
Black - Negative
3.
4.
3. Adding an accessory
Using two fingers or a tool remove the
magnetic insert and the LED module by
pulling sharply downwards.
Unscrew the tilt / fixed magnetic ring
from the light engine to access the
accessory slot. The accessory must be
placed on the inside of the tilt / fixed
magnetic ring.
4. Adjusting tilt angle and direction
Only valid for adjustable configuration
Using two fingers or a tool remove
the magnetic insert but leave the LED
module inside the trim. If the LED
module comes out with the insert
please reinsert it into the trim.
The module can be pushed inwards to
rotate up to 35º. It can also be rotated
on the magnetic surface.
2. Changing beam angle
WARNING
luminaire may be hot.
Allow to cool before touching.
Using two fingers or a tool remove the
magnetic insert and the LED module by
pulling sharply downwards.
Unscrew the tilt / fixed magnetic ring
from the light engine to access the optic
disc.
When installing the optic disc the
text MUST be facing you.
2.
For IP54 version the tilt angle
should be set before the
magnetic insert is installed.
