© 2017 Precision Lighting Ltd. We reserve the right to change details of design, materials and finish. Version 02.17
instruction manual
Minimo 11/16 Pro
33
20mm
3/4 inch
106mm
4 1/5 inch
Cutout ø65mm
2 1/2 inch
3mm
1/8 inch
ø76mm
3 inch
Cutout ø65mm
2 1/2 inch
88mm
3 1/2 inch
1.5mm
1/20 inch
ø76mm
3 inch
20mm
3/4 inch
135mm
5 1/3 inches
35° tilt
35° tilt
35° tilt
35° tilt
Springs parallel
Minimo 16 Fixed/Tilt
3-25mm
1/8 - 1 inch
Minimo 11 Fixed/Tilt
20mm
3/4 inch
106mm
4 1/5 inch
Minimo 11 Fixed/Tilt Trimless
20mm
3/4 inch
135mm
5 1/3 inches
Cutout ø76mm
3 inch
4mm
ø59mm
3 inch
3-25mm
1/8 - 1 inch
Minimo 16 Fixed/Tilt Trimless
86 mm
3 2/5 inch
Minimo 11/16 Pro is a miniature recessed
92 CRI LED luminaire offering 360º pan with
35º tilt.
Minimo 11 Pro - 6W, 513lm
Minimo 16 Pro - 8.4W, 665lm
These instructions cover procedures for
all versions of Minimo 11 Pro with bezels
including:
Fixed and adjustable configurations
Chamfered and flat bezel configurations
Decorative and Pinhole apertures
IP20 and IP54 configurations
Trimless configurations
1. All systems must be installed by a suitably
qualified professional only. Installations
must conform to national installation
and accident prevention regulations.
2. Ensure that the luminaire is switched off at
mains supply before installing or removing.
3. Do not install IP20 luminaires in a
damp or wet location. Do not install
any fixture closer than 150mm (6
inches) from any combustible material.
4. To reduce the risk of fire and burns, do
not install these systems where exposed
bare conductors can be shorted or
contact any conductive materials. Do not
conceal or extend exposed conductors
through a building wall.
5. Ensure all connections are tight. Bad
connections can cause overheating,
arcing and a potential fire risk.
6. Wire supply connections must be made
with U.L or compatible testing agency-
approved connectors.
Always use
appropriate optics and ensure they are
fitted securely.
7. Install and use only as described in this
Precision Lighting manual.
8. Use Precision Lighting recommended
optics and accessories only.
9. Luminaires may be hot, allow to cool
before touching.
10. Access to serviceable electrical
components should be kept available
for maintenance purposes.
11. Regular cleaning of these products is
important. Switch off at mains supply
and allow to cool before touching.
Clean fittings with a microfibre cloth.
Then reconnect the power supply.
