© 2018 Precision Lighting Ltd. We reserve the right to change details of design, materials and finish. Version 07.19
4. Snoot Removal and Changing the Optic
WARNING
switch off power to mains
before installation.
To remove snoot, rotate snoot
anti-clockwise and lift off.
Once snoot has been removed, the optic
can be changed. Remove optic from PCB.
To install new optic, align optic base pins
with slots on PCB and set into place.
Then place snoot over optic and rotate
clockwise to securely fix to luminaire.
There should be no gap between the
snoot and the luminaire body.
5. Changing the Snoot
To remove snoot, rotate snoot
anti-clockwise and lift off.
Place new snoot over optic and rotate
clockwise to securely fix to luminaire body.
There should be no gap between the
snoot and the luminaire body.
4.
5.
6. Electrical Installation
WARNING
switch off power to mains
before installation.
Note:
Due to small Minipoint size, drivers
must be located remotely; cut out is too
small for dimmable drivers to pass through.
See electrical instructions for wiring
schematic. Ensure circuit is
wired in
series
. Please
only use
the following
compatible drivers listed below:
•
Eldoled 350mA Constant Current
20W 0-10V (PSCC-20-350-A-EL)
•
Eldoled 350mA Constant Current
20W DALI (PSCC-20-350-D-EL)
Note:
Do not install more than 10
minipoints in one circuit.
6.
Note:
Maintain correct polarity when wiring. Incorrect wiring will
cause serious damage and will not be covered by warranty. Must
be installed according to SELV regulations.
Wire specification: 24 AWG, double insulated teflon wire.
Red
= Positive
Black
= Negative
WARNING
Do not connect or disconnect under load.
Ensure driver has not been powered for a minimum of 1 minute
before reconnecting the LED module after disconnecting.
Do not
hot plug.
Failure to this instruction will lead to serious damage of
the LED module and driver and will not be covered by warranty.
+
Positive (Red)
from supply
+
Positive (Red)
from supply
-
Negative (Black)
from supply
-
Negative (Black)
from supply
SINGLE MINIPOINT
MULTIPLE MINIPOINTS - MUST BE WIRED IN
SERIES
