P
RO
V
U
™ PD6088/PD6089 Modbus
®
Scanner
Instruction Manual
19
Setup and Programming
Overview
There are no jumpers involved in the scanner setup
procedure.
Setup and programming is done using ScanView
software or through the front panel buttons.
After power and signal connections have been
completed and verified, apply power to the scanner.
Front Panel Buttons and Status
LED Indicators
PD6088
PD6089
Button Symbol
Description
Menu
F1
PREV/Right arrow/F1
F2
NEXT/Up arrow/F2
F3
SCAN/Enter/F3
PREV
Go to previous PV
NEXT
Go to next PV
Note:
F4 is a digital input. Alarms 5-8 are enabled when relay
expansion module is installed.
LED
Status
1-8
Alarm 1-8 indicator
1-8
M
Flashing: Relay in manual control
mode
/8
/16
Displays PV to nearest 1/8th or
1/16th of an inch
1-4
Flashing: Relay interlock switch open
F
Communications Fault Condition
PAUSE
Press SCAN to pause scanning
PLAY
Press SCAN to resume scanning
STOP
Stop scan on alarm
Note:
LEDs for relays in manual mode flash with the “M” LED
every 10 seconds.
“M” flashing by itself indicates Aout –
manual control is used.
•
Press the Menu button to enter or exit the
Programming Mode at any time.
•
Press the Right arrow button to move to the next
digit during digit or decimal point programming.
•
Press the Up arrow button to scroll through the
menus, decimal point, or to increment a digit.
•
Press the Enter button to access a menu or to
accept a setting.
•
Press and hold the Menu button for three
seconds to access the advanced features of the
scanner.
•
Press the SCAN/Enter button once to pause
scanning (Pause LED flashes), then press the
SCAN/Enter button again to resume scanning
(Play LED turns on).
•
Press NEXT to go to the next PV; auto scan
resumes after 10 seconds of inactivity.
•
Press PREV to go to the previous PV; auto scan
resumes after 10 seconds of inactivity.
