Model PD6300 Pulse Input Rate/Totalizer
Instruction Manual
29
SETUP AND PROGRAMMING
•
The meter has been factory calibrated to read input
frequency in Hz (pulses/sec). The calibration
equipment is certified to NIST standards.
•
Use
the
K-Factor
menu to match the rate/totalizer with
a flowmeter’s k-factor (pulse/unit of measure).
•
Or use the
Scale
menu to scale the pulse input
(pulse/sec) without a signal source.
•
Or
use
Cal
menu to calibrate the rate/totalizer using a
signal source.
Overview
There are two switches, located to the right of the input connector, which
must be configured according to the input level and type. Jumper J4
located inside the meter, behind the input signal connector, is used to
select the excitation voltage (24 V*, 10 V or 5 V) which is supplied to the
P+ and P- wiring terminals.
Setup and programming is done through the front panel buttons.
After power and input signal connections have been completed and
verified, apply power to the meter.
*
Default setting
