P
RO
V
U
PD6210 Analog Input Batch Controller Instruction Manual
22
Display Functions and Messages
The controller displays various functions and messages during setup, programming, and operation. The
following table shows the main menu functions and messages in the order they appear in the menu.
Display
Parameter Action/Setting
Description
setup
Setup
Enter
Setup
menu
Input
Input
Enter
Input
selection menu
volt
0-10 VDC
Set input for
10 VDC input
mA
4-20 mA
Set input for 4-20 mA input
Total
Total
Enable or disable totalizer
features
unitS
Units
Select the display units/tags
rate
Rate
Select the display units for
rate
total
Total
Select the display units for
total
Gtotal
Grand Total
Select the display units for
grand total
Dec pt
Decimal
point
Set decimal point for rate,
total, grand total
prog
Program
Enter the
Program
menu
InCAL
Input
Calibration
Enter the
Input Calibration
menu
sCalE
Scale
Enter the
Scale
menu
Cal
Calibrate
Enter the
Calibrate
menu
Inp 1
Input 1
Calibrate input 1 signal or
program input 1 value
Dis 1
Display 1
Program display 1 value
Inp 2
Input 2
Calibrate input 2 signal or
program input 2 value (up
to 32 points)
Dis 2
Display 2
Program display 2 value
(up to 32 points)
Error
Error
Error, calibration not
successful, check signal or
programmed value
T tb
Total time
base
Enter totalizer time base for
seconds, minutes, hours or
day.
T Cf
Total
conversion
factor
Enter the conversion factor
decimal point and the
conversion factor.
mode
Batch
mode
Automatic or manual batch
control
T dly
Time delay
Set time delay for automatic
batch restart
GT tb
Grand total
time base
Program grand total time
base
Display
Parameter Action/Setting
Description
GT CF
Grand total
conversion
factor
Program grand total
conversion factor
GT rst
Grand total
reset
Program grand total reset
mode: auto or manual
dsplay
Display
Enter the
Display
menu
Line 1
Display line
1
Press Enter to assign the
Upper display parameter
(default: PV or rate)
Line 2
Display
Line 2
Press Enter to assign the
Lower display parameter
(default: total)
d-Inty
Display
intensity
Set display intensity level
from 1 to 8
RELaY
Relay
Enter the
Relay
menu
Assign
Assignment
Assign relays to rate, total
(batch control), grand total,
or Modbus controlled.
Asign1
Assign 1
Relay 1-2 assignment
TotaL
Total
Assign relay to batch
control
Gtotal
Grand total
Assign relay to grand total
mbus
Modbus
Assign relay to Modbus
input
rate
Rate
Assign relay to rate
precls
Batch total
relay
preclose
For relays beyond the first
assigned to total, a
preclose amount may be
entered.
RLY 1
Relay 1
Relay 1 setup
Act 1
Action 1
Set relay 1 action
1
Auto
Automatic
Set relay for automatic
reset
A-
man
Auto-
manual
1
Set relay for automatic &
manual reset
any time
1
(relays assigned
to rate)
LatcH
Latching
1
Set relay for latching
operation (relays assigned
to rate)
1
Lt-CLr
Latching-
cleared
1
Set relay for latching
operation with manual reset
only after alarm condition
has cleared (relays
assigned to rate)
1
