Helios PD2-6200 Analog Input Flow Rate/Totalizer
Instruction Manual
25
Display Functions & Messages
The meter displays various functions and messages
during setup, programming, and operation. The
following table shows the main menu functions and
messages in the order they appear in the menu.
Display Functions & Messages
Display
Parameter
Action/Setting
Description
setup
Setup
Enter
Setup
menu
Input
Input
Enter
Input
selection
menu
nmA
4-20 mA
Set meter for 4-20 mA
input
volt
0-10 VDC
Set meter for
10 VDC
input
Total
Total
Enable or disable
totalizer features
d-SCAL
Dual-scale
Enter
d-SCAL
menu and
select
Yes
for dual- scale
or
No
for single scale
display
units
Units
Select the display
units/tags
rate
Rate
Select the display units
for rate
total
Total
Select the display units
for total
Gtotal
Grand Total
Select the display units
for grand total
Dec pt
Decimal
point
Set decimal point for rate,
total, grand total
prog
Program
Enter the
Program
menu
InCAL
Input
Calibration
Enter the
Input
Calibration
menu
sCalE
Scale
Enter the
Scale
menu
Cal
Calibrate
Enter the
Calibrate
menu
Inp 1
Input 1
Calibrate input 1 signal or
program input 1 value
Dis 1
Display 1
Program display 1 value
Inp 2
Input 2
Calibrate input 2 signal or
program input 2 value
(up to 32 points)
Dis 2
Display 2
Program display 2 value
(up to 32 points)
Error
Error
Error, calibration not
successful, check signal
or programmed value
T tb
Total time
base
Program total time base
T CF
Total
conversion
factor
Program total conversion
factor
T rst
Total reset
Program total rest mode:
auto or manual
GT tb
Grand total
time base
Program grand total time
base
Display Functions & Messages
Display
Parameter
Action/Setting
Description
GT CF
Grand total
conversion
factor
Program grand total
conversion factor
GT rst
Grand total
reset
Program grand total rest
mode: auto or manual
Auto
Automatic
Press Enter to set
automatic total reset
T dly
Time delay
Program time delay for
total auto reset
nmAn
Manual
Press Enter to reset total
manually
dsplay
Display
Enter the
Display
menu
Line 1
Line 1
Press Enter to assign the
Main display parameter
(default: PV or rate)
Line 2
Line 2
Press Enter to assign the
small display parameter
(default: total)
d-Inty
Display
intensity
Set display intensity level
from 1 to 8
RELaY
Relay
Enter the
Relay
menu
Assign
Assignment
Assign relays to rate,
total, or grand total
Asign1
Assign 1
Relay 1 assignment
totAL
Total
Assign relay to total
G total
Grand total
Assign relay to grand
total
nm bus
Modbus
Select to display Modbus
input or to assign
Modbus input as the
analog output source
rate
Rate
Assign relay to rate
RLY 1
Relay 1
Relay 1 setup
Act 1
Action 1
Set relay 1 action
Auto
Automatic
Set relay for automatic
reset
A-nman
Auto-manual
Set relay for automatic &
manual reset
any time
LatCH
Latching
Set relay for latching
operation (relays
assigned to rate)
Lt-CLr
Latching-
cleared
Set relay for latching
operation with manual
reset only after alarm
condition has cleared
(relays assigned to rate)
Altern
Alternate
Set relay for pump
alternation control (relays
assigned to rate)
Sanmpl
Sampling
Set relay for sampling
operation
