Trident Series PD765 Process & Temperature Meters
Instruction Manual
12
Connections
All connections are made to removable screw
terminal connectors located at the rear of the meter.
•
Use copper wire with 60°C or 60/75°C insulation
for all line voltage connections. Observe all safety
regulations. Electrical wiring should be performed
in accordance with all applicable national, state,
and local codes to prevent damage to the meter
and ensure personnel safety.
Connector Labeling
The connectors label, affixed to the meter, shows the
location of all connectors available with requested
configuration. It also identifies the location of the
RTD/TC selector switch. The images below show all
connector configurations for the PD765. Note that the
connector in the upper left of the diagram has different
configurations based on the model.
Note:
# on the following figures refers to power options.
(Example: PD765-6R0-00)
Figure 4. Connector Labeling for PD765-#R0-00
Figure 5. Connector Labeling for PD765-6R0-10
Figure 6. Connector Labeling for PD765-#R2-00
Figure 7. Connector Labeling for PD765-6R2-10
Figure 8. Connector Labeling for PD765-#R3-00
Figure 9. Connector Labeling for PD765-6R3-10
Figure 10. Connector Labeling for PD765-6R3-20
