P
RO
V
U
™ PD6000 Analog Input Process Meter
Instruction Manual
17
Setup and Programming
There is
no need to recalibrate
the meter
when first received from the factory.
The meter is
factory calibrated
prior to
shipment for milliamps and volts with
calibration equipment that is certified to NIST
standards.
Overview
There are no jumpers to set for the meter input
selection.
Setup and programming is done using MeterView Pro
or through the front panel buttons.
After power and input signal connections have been
completed and verified, apply power to the meter.
Front Panel Buttons and Status
LED Indicators
Button
Symbol
Description
LED
Status
Menu
1-8
Alarm 1-8
indicator
Right
arrow/F1
1-8
M
Flashing:
Relay in
manual
control mode
Up arrow/F2
T
Flashing:
Tare
Enter/F3
1-8
Flashing:
Relay
interlock
switch open
Note:
F4 is a digital input. Alarms
5-8 are enabled when relay
expansion module is
installed.
Note:
LEDs for relays in
manual mode flash
with the “M” LED every
10 seconds. “M”
flashing by itself
indicates Aout
–
manual control is used.
•
Press the Menu button to enter or exit the
Programming Mode at any time.
•
Press the Right arrow button to move to the next
digit during digit or decimal point programming.
•
Press or hold the Up arrow button to scroll
through the menus, decimal point, or to
increment the value of a digit.
•
Press the Enter button to access a menu or to
accept a setting.
•
Press and hold the Menu button for three
seconds to access the advanced features of the
meter.
