P
RO
V
U
™ PD6001 Analog Input Feet & Inches Meter
Instruction Manual
20
Setup and Programming
There is
no need to recalibrate
the meter
when first received from the factory.
The meter is
factory calibrated
prior to
shipment for milliamps and volts with
calibration equipment that is certified to
NIST standards.
Overview
There are no jumpers to set for the meter input
selection.
Setup and programming is done using MeterView Pro
or through the front panel buttons.
After power and input signal connections have been
completed and verified, apply power to the meter.
Front Panel Buttons and Status
LED Indicators
Button Symbol
Description
Menu
Right arrow/F1
Up arrow/F2
Enter/F3
LED
State
Indication
1-8
Steady
Alarm condition based on set
and reset points, independent
of relay status in certain
configurations. (Available on all
meter configurations, including
those without relays installed)
1-8
Flashing
Relay interlock switch open
1-8 & M
Flashing
Relay in manual control mode
T
Flashing
Meter in Tare mode
M
Flashing
Analog ouput in manual control
mode
8
Steady
Eighths of an inch
16
Steady
Sixteenths of an inch
Symbol
Description
FT
Feet value
IN
Inches value
- -
Designation separators
•
Press the Menu button to enter or exit the
Programming Mode at any time.
•
Press the Right arrow button to move to the next
digit during digit or decimal point programming.
•
Press or hold the Up arrow button to scroll
through the menus, decimal point, or to
increment the value of a digit.
•
Press the Enter button to access a menu or to
accept a setting.
•
Press and hold the Menu button for three
seconds to access the advanced features of the
meter.
