Precision Digital Corporation Loop Leader+ PD4-6624, Instruction Manual

Page: 20 / 78

PD4-6624 & PD4-6628 Loop-Powered Flow Rate/Totalizers Instruction Manual
20
Wall Mounting Instructions
The meter can be mounted to any wall using the four
provided mounting holes. Note that the bottom mounting
holes are located underneath the lower door panel. To
mount the meter to a wall, follow these instructions
•
Prepare a section of wall approximately 11" x 13"
(280 mm x 330 mm) for meter mounting by marking
with a pencil the mounting holes (shown in
Figure 1 )
on the wall.
•
Select the appropriate mounting screws for the
mounting surface to be used. The mounting holes
diameter is shown on
Figure 2 .
Note: Mounting screws are not included.
•
Using a drill bit slightly smaller than the girth of the
mounting screws, pre-drill holes at the mounting
locations previously marked.
•
Insert mounting screws into the four mounting holes
and screw them into the pre-drilled holes.
DO NOT
overtighten the mounting screws as it is possible that
the enclosure could crack and become damaged.
Figure 1. Meter Mounting Holes Location
Figure 2. Meter Mounting Holes Dimensions
Mounting Dimensions
Figure 3. Meter Dimensions
– Side View
Figure 4. Meter Dimensions - Front View
Conduit Holes Location
Figure 5. Conduit Holes Location
– Bottom View
Mounting Hole
Mounting Hole
Mounting Hole
Mounting Hole
Lower
Door
Panel