Precidia ipocket232, User Manual

Page: 65 / 106

7 Accessing System Information iPocket 232 User Guide
23-CML000293 iPocket232 Inc. 59
Table 7.1: System Uptime on the System Status Page
Parameter Description
Firmware
Revision
The software version currently installed in the iPocket 232 with the
date of the software build in parentheses.
Serial Port
This section describes the configured serial port in the iPocket 232 . It consists of a header line and a
table showing the data received and transmitted.
N
OTE
:
If the serial port is not configured, or incorrectly configured, this section does not appear on the
System Status page.
The header contains is formatted as follows:
Port #1 [
port type
] (
data formatting
/
session mode
,
connection status
)
•Port type: null if it is not connected, or serial if connected.
•Protocol: the data formatting, the session mode, the connection status (connected, connecting, or idle)
The information below the header shows the number of bytes, the number of packets, and the average
bytes per packet received and transmitted by the unit.
Network Routing
This section reveals how the system is handling the data going through the iPocket 232 in the same style
as the “print-route” command. Table 7.2 describes each parameter in the Network Routing section.:
Table 7.2: Network Routing Parameters
Parameter Description
Local
The IP Address of the unit (configured in Ethernet Settings or
obtained through DHCP).
Network
Address
The network address, derived from the IP address and subnet mask,
for which this entry applies.
Subnet
Mask
The Subnet Mask for which this entry applies (configured in
Ethernet Settings or obtained through DHCP).
Gateway
The Gateway (router) address for which this entry applies
(configured in Ethernet Settings or obtained through DHCP).
Iface
The interface used to connect to the remote host. eth = Ethernet
Pkts-In
Total number of packets received by the unit since the last reset.