Model 3710 Plasma Control Console
Operator’s
Manual
_____________________________________________________________________________________________________________________
Issued: 03/11
Page
28
2. Make two marks approximately 1/2 in. (13 mm) above the de-
sired cabinet height and 21 1/2 in. (546 mm) apart at the desired
console location (use a carpenter’s level to line up the marks level
with each other).
3. Drill a 3/8 in (10 mm) hole at each mark. Drill through the wall, if
possible.
4.
Place lock washers and flat washers on two 3/8 in (10 mm) diameter
bolts of sufficient length to pass through the wall (washers, bolts, nuts
are purchaser-supplied).
5. Have two workers lift and hold the console so its mounting brack-
ets match up to the drilled holes.
6. Pass the bolts through the mounting brackets and then through
the drilled holes.
7. On the opposite side of the wall from the console, Place a flat
washer of sufficient size and strength to prevent bolt from tearing out
of wall material, a lock washer and a hex nut on each bolt. Tighten
both nuts until secure. The two workers can then release the console.
Above instructions are for the recommended mounting method. If
unable to drill through wall, (cement block or other masonry, for
example), use lag screws and shields sufficient to support console
weight (100 lbs. [45.4 kg]).
Mounting to a sheet-rock and frame wall is NOT recommended. If this
type of mounting is attempted, the wall must be reinforced and
modified to support the console and match its mounting hardware.
Note that the mounting brackets WILL NOT match up to standard 16
in. (406 mm) wall stud placement.
3.2
Location
Verify that required utility connections (electrical, gases, etc.) described in
section 2 are located near the console.
Place system components so all interconnecting cables and hoses
terminate without strain.
